Direct Supply Metal Cutting Onsite Oxygen Generator

Direct Supply Metal Cutting Onsite Oxygen Generator is one kind of oxygen generator suitable for use in workshop where need oxygen for metal cutting. For many metal cutting applications, cylinder hold oxygen is often used. But to achieve oxygen filling into cylinder, high pressure oxygen compressor and filling station is needed, which increase the investment cost a lot. In order to reduce the investment cost, Gamma developed out this 99% purity industrial oxygen generator, it supplies 5 bars oxygen into one oxygen storage tank. When the pressure inside the tank is smaller than certain degree, the machne start to run again. In this way, there is no need for oxygen compressor and no need for oxygen cylinder.

This industrial oxygen generator adapts PSA technology, produce oxygen from air. It use Air Compressor as raw material supplier, use three filters, one dryer and one oil remover to get rid of impurities from the compressed air . Then the treated air goes into one air tank to stablize pressure and flow rate. Then the compressed air enters one oxygen separator, this is the key part for oxygen equipment. After air pass through this part, high purity oxygen (93%) is collected. The collected air is sent to one buffer tank then send to industrial applications. c.

93% purity industrial oxygen generator specification

Item		Technical parameter	Remarks
Model No.		POM93-90
Oxygen index	Purity	≥93%
	Ave flow	≥90 Nm3/h	20°C,101.325Kpa
	Pressure	≥5 bars	Gauge pressure
	Dew point	≤-40°C	Normal pressure
Noise		≤80 Db(A)	One meter from equipment

Industrial High Purity PSA Oxygen Equipment Features

Skid structure, easy installation.

When oxygen generator reaches site, just connect the air compressor into main machine, then with one simple touch on the start, the whole machine starts to work, no need for site installation, site training,etc. No need for Gamma engineers go to site, further saving customer`s cost.

Special filling device

Making the fill of molecular sieve achieve max density and evenness. Getting rid of molecular sieve creeping and wearing and [tunnel effect" from the root. Therefore the molecular sieve has longer lifetime, higher utility ratio and lower material air consumption.

Special gas distributors

Equipped at both top and bottom side of the adsorption tower

adapting multi-layer hole plate structure and special hole arrangement. These makes gas distribution within tower more efficient.

Pipeline flow speed control technology

Making the molecular sieve avoid damage caused by collision by [boiling" at the top of adsorption tower, no need extra pressing device.

Advanced middle bed layer pressure balancing process

Can be regarded as a four tower structure with series connection of pre-adsorption stage and clean adsorption stage, achieving higher purity oxygen.

93% purity industrial oxygen generator packing and shipping

After sales service

Free customer site installation guidance, free training for operation and maintenance. No need to pay for Gamma engineer's site service.

One years operation warranty. Should any trouble happened, Gamma provide and send parts free of charge. If necessary, Gamma engineer comes to site at our own cost.

Contact us if you need more details on Direct Supply Oxygen Generator. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Metal Cutting Oxygen Generator、Onsite Oxygen Generator. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Industrial Oxygen Generator > 99% Purity Industrial Oxygen Generator